Smdr Output Options - NEC SL1100 Programming Manual

ISSUE 6.0
Program 35 : SMDR Account Code Setup
Level:
IN
Description
Use Program 35-02 : SMDR Output Options to set the SMDR (Station Message Detail Recording)
output options for each of the eight SMDR ports. Refer to the following chart for a description of each
option, its range and default setting.
Input Data
SMDR Port Number
Item Item
No.
01 Toll Restricted Call
02 PBX Calls
03 Trunk Number or
Name
04 Summary (Daily)
05 Summary (Weekly)
06 Summary (Monthly)
07 Toll Charge Cost
08 Incoming Call
09 Extension Number or
Name
10 All Lines Busy (ALB)
Output
11 Walking Toll Restric-
tion Table Number
12 DID Table Name Out-
put
Programming Manual

35-02 : SMDR Output Options

Input Data
0 = Not Displayed SMDR can include or exclude calls
1 = Displayed blocked by Toll Restriction.
0 = Not Displayed When the system is behind a PBX, SMDR
1 = Displayed can include all calls (1) or just calls dialed
using the PBX trunk access code (0).
0 = Name Select whether the system should display
1 = Number the trunk name (0) or the number (1) on
SMDR reports.
0 = Not Displayed Set this option to (1) to have the SMDR re-
1 = Displayed port provides a daily summary (at midnight
every night).
0 = Not Displayed Set this option to (1) to have the SMDR re-
1 = Displayed port provides a weekly summary (every
Saturday at midnight).
0 = Not Displayed Set this option to (1) to have the SMDR re-
1 = Displayed port provides a monthly summary (at mid-
night on the last day of the month).
0 = Not Displayed Set this option to (1) have the SMDR re-
1 = Displayed port include toll charges.
0 = Not Displayed Enable this option (1) to have the SMDR
1 = Displayed report include incoming calls. If you disa-
ble this option (0), incoming calls do not
print.
0 = Name Set this option (1) to have the SMDR re-
1 = Number port include extension numbers. Set this
option (0) to have the SMDR report include
extension names.
0 = Not Displayed Determine if the All Lines Busy (ALB) indi-
1 = Displayed cation should be displayed.
0 = Not Output
1 = Output
0 = Not Displayed Determine if the DID table name should be
1 = Displayed displayed.
1 ~ 2
Description
If this option is set to 1, Program
35-02-14 must be set to 0.
SL1100
Program
35
Default
1
1
1
1
1
1
1
1
1
0
1
0
2-351