Selectable Display Messages - NEC SL1100 Programming Manual

SL1100
Level:
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages.
Program
There are 20 alphanumeric messages, with up to 48 characters. Use the following chart when
programming messages.
20
Use this keypad digit ...
Clear/Back
Input Data
Selectable Display Message Number
Item No.
01
Default
Number
2-196
Program 20 : System Option Setup
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters :
*
# # = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow soft
key instead to accept and/or add a space.)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Item

Selectable Display Messages

1 IN MEETING UNTIL ## : ##
2 MEETING ROOM - ########
3 COME BACK ## : ##
4 PLEASE CALL ###########
20-16 : Selectable Display Messages
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
Input Data
48 characters
Message
Program 20 : System Option Setup
ISSUE 6.0
01 ~ 20
Default
Refer below