Ars/F-Route Table - NEC SL1100 Programming Manual

ISSUE 6.0
Level:
IN
Description
Use Program 44-05 : ARS/F-Route Table to set the ARS/F-Route table. There are four kinds of
order. If the higher priority trunk groups are busy, the next order group is used. If a lower priority route
is selected, the caller may be notified with a beep tone.
Input Data
ARS/F-Route Table Number
Priority Number
Item Item
No.
01 Trunk Group Number
02 Delete Digits
03 Additional Dial Num-
ber Table
04 Beep Tone
05 Gain Table Number
for Internal Calls
06 Gain Table Number
for Tandem Connec-
tions
07 ARS Class of Service
08 Dial Treatment
09 Maximum Digit
11 Network Specified Pa-
rameter Table
Programming Manual
Program 44 : ARS/F-Route Setup
Input Data
0 = No Setting Select the trunk group number to use for
1 ~ 25 = Trunk Group the outgoing ARS call.
101 ~ 104 = Networking
(V1.5 Added)
255 = Extension Call
0 ~ 255 Enter the number of digits to be deleted
(255 = Delete All) from the dialed number.
0 ~ 100 Enter the table number (defined in Pro-
gram 44-06) for additional digits to be di-
aled.
0 = Off Select whether or not a beep is heard if a
1 = On lower priority trunk group is used to dial
out.
0 ~ 100 Select the gain table number to use for the
0 = No Setting internal call (defined in Program 44-07).
0 ~ 100 Select the gain table number to use for the
0 = No Setting tandem call (defined in Program 44-07).
0 ~ 16 Select the ARS Class of Service to use for
0 = No ARS Class (Call the table. An extension ARS COS is deter-
Restricted) mined in Program 26-04-01.
0 ~ 15 Select the Dial Treatment to use for the ta-
ble. If a Dial Treatment is selected, Pro-
grams 44-05-02 and 44-05-03 are ignored
and the Dial Treatment defined in Program
26-03-01 is used instead.
0 ~ 24 Input the maximum number of digits to
send when using the F-Route.
0 ~ 16 Enter a table number from Program 26-12.

44-05 : ARS/F-Route Table

001 ~ 100
1 ~ 4
Description
SL1100
Program
44
Default
0
0
0
0
0
0
0
0
0
0
2-395