Single Line Telephone Basic Data Setup - NEC SL1100 Programming Manual

SL1100
Level:
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various single line
Program
telephone options.
15
Input Data
Item
No.
01 SLT Signaling
Type
03 Terminal Type
04 Flashing
05 Trunk Polarity
Reverse
06 Extension Polari-
ty Reverse
07 Enabled On-
Hook When
Holding (SLT)
08 Answer On-Hook
when Holding
(SLT)
2-134
Program 15 : Extension, Basic Setup

15-03 : Single Line Telephone Basic Data Setup

Extension Number
Item Input Data
0 = DP
1 = DTMF
0 = Normal
1 = Special
0 = No
1 = Yes
0 = Off
1 = On
0 = Disable (Off)
1 = Enable (On)
0 = No
1 = Yes
0 = Disable (No)
1 = Yes (Enable)
Maximum eight digits
Description
Use this option to tell the system the
type of dialing the connected tele-
phone uses.
For Analog Wireless telephones to
function correctly, this must be set to
0 (dial pulse). If this option is set for
DTMF, after an outside call is
placed, the system cannot dial any
additional digits.
This program change is automatical-
ly performed when the Analog Wire-
less telephone is registered. When
upgrading software from prior ver-
sions, the previous default of 1 is
saved from the prior database so
this option must be changed man-
ually.
Enter 1 for this option to allow a sin-
gle line port to receive DTMF tones
after the initial call setup. Enter 0 to
have the port ignore DTMF tones af-
ter the initial call setup. For Voice
Mail, always enter 1 (e.g., receive
DTMF tones).
Enables/disables Flash for single
line telephones.
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
Program 15 : Extension, Basic Setup
ISSUE 6.0
Default Related
Program
1 15-03-03
45-01-01
0 15-03-01
45-01-01
1
0
0
1 11-12-45
1 11-12-46