NEC SL1100 Programming Manual page 366

SL1100
Item
No.
04 Route Table Set-
up of Target Dial
Program
34
05 ANI/DNIS Display
as Target Dial
Name
06 Routing SPD Ta-
ble Setup
07 Routing on ANI/
DNIS Error
08 Routing When
Destination Busy
or No Answer
2-346
Item Input Data
0 = SPD Table
(Program 13-03)
1 = DID Table
(Program 22-11)
0 = Display Off
1 = Display On
Start = 0, 100 ~ 900
End = 0, 99 ~ 999
0 = Play Busy Tone to
Caller
1 = Route Caller to
Ring Group Specified
in Program 25-03
(Transfer)
0 = Play Busy or Ring-
back Tone to Caller
(Busy/ NoAns)
1 = Route Caller to
Ring Group Specified
in Program 25-04
(Transfer)
Description
The option sets how the system
uses the route data (gathered in
Item 3) to route incoming ANI/DNIS
calls.
If option 2 is selected, and the call is
to be routed using the DID table (1),
up to eight digits can be matched.
The number of expected digits set in
Program 22-09-01 must match the
ANI digits defined in Program
22-11-01. For example, if an ANI/
DNIS number received was
2035551234 3001 and Program
* * *
22-09- 01 = 4, the entry in 22-11-01
must be 1234 with the defined target
extension.
If the call is to be routed using the
ABB table (0), up to 36 digits can be
matched. Define the range of the
ABB table to be used in Program
34-09-06. The data is compared to
the entries in Program 13-04-01 and
then routed according to Program
13-04-03.
Use this option to set whether or not
ANI data should appear on tele-
phone displays as part of Caller ID
display.
Use this option to define which part
of the ABB Table set up in Program
13-04 the system uses for ANI/DNIS
Caller ID look-ups and ANI/DNIS
routing.
This is required if Items 4 and 5
above are 1 (Caller ID on). When
you specify a starting and end ad-
dress, the system uses the part of
the table for look-ups.
When you specify a starting address
and length, the system uses that
part of the table for routing. If the in-
coming ANI/DNIS number data
matches the Number entry in the ta-
ble, the system routes according to
the associated Name data. That da-
ta can be an extension, Department
Group pilot number, the voice mail
master number or a trunk ring
group.
This option lets you determine how
the system handles an ANI/DNIS
call if a data error is detected in the
incoming data string.
This option lets you determine how
the system handles an ANI/DNIS
call if destination is busy or does not
answer.
Program 34 : Tie Line Setup
ISSUE 6.0
Default Related
Program
COS 01 = 0 13-04
COS 02 ~ 15 = 0 22-11-03
34-09-05
COS 01 = 1 13-04
COS 02 ~ 15 = 0 20-09-02
22-11-03
23-09-04
COS 01 = 13-04
Start = 900
End = 999
COS 02 ~ 15 =
Start = 0
End = 0
COS 01 = 1 25-03
COS 02 ~ 15 = 0
COS 01 = 0 25-04
COS 02 ~ 15 = 0