Chapter 1 Introduction; Section 1 Before You Start Programming; Section 2 How To Use This Manual - NEC SL1100 Programming Manual

Introduction
S 1 BEFORE YOU START PROGRAMMING
ECTION
Before customizing your system be sure to read this chapter first.
This chapter provides you with detailed information about the system programs. By changing a
program, you change the way the feature associated with that program works. In this chapter, you find
out about each program, the features that the program affects and how to enter the program data into
system memory.
This Manual is created for System : SL1100
S 2 HOW TO USE THIS MANUAL
ECTION
This section lists each program in numerical order. For example, Program 10-01 is at the beginning of
the section and Program 92-01 is at the end. The information on each program is subdivided into the
following headings :
Description describes what the program options control. The Default Settings for each program are
also included. When you first install the system, it uses the Default Setting for all programs. Along with
the Description are the Conditions which describe any limits or special considerations that may apply
to the program.
The program access level is just above the Description heading. You can only use the program if your
access level meets or exceeds the level the program requires. Refer to
Mode on page 1-2 for a list of the system access levels and passwords.
Feature Cross Reference provides you with a table of all the features affected by the program. You
will want to keep the referenced features in mind when you change a program. Customizing a feature
may have an effect on another feature that you did not intend.
Telephone Programming Instructions shows how to enter the program data into system memory.
For example :
1. Enter the programming mode.
2. 15-07-01
tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do, you
will see the message "15-07-01 TEL" on the first line of the telephone display. This indicates the
program number (15-07), item number (01), and that the options are being set for the extension. The
second row of the display "KY01 =
01. The third row allows you to move the cursor to the left or right, depending on which arrow is
*
Programming Manual
15-07-01 TEL
KY01 = *01
-
01" indicates that Key 01 is being programmed with the entry of
*
How to Enter Programming
+
1
1-1