Sip System Information Setup - NEC SL1100 Programming Manual

ISSUE 6.0
Program 10 : System Configuration Setup
Level:
SA
Description
Use Program 10-28 : SIP System Information Setup to set up basic SIP trunking.
Input Data
Profile
(V5.0 Added)
Item Item
No.
01 Domain Name
02 Host Name
03 Transport Protocol
04 UserID (V5.0 Deleted)
05 Domain Assignment
06 IP Trunk Port Binding
Programming Manual

10-28 : SIP System Information Setup

Input Data
Up to 64 Characters Set the domain name of the SIP-URL.
(ex. : UserID@Host-
Name.DomainName)
Up to 48 Characters Set the host name of the SIP-URL.
(ex. : UserID@Host-
Name.DomainName)
0 = UDP Set the protocol for the connection.
1 = TCP
Up to 32 Characters User ID in the SIP Invite Setup message.
When assigning the Use it for outbound caller ID information if
User ID, the ID may con- no information is assigned in commands
tain only alpha charac- 21-17, 21-19, 15-16, 14-12 and 10-36. A
ters. (A space and/or call cannot be completed across the span
special characters are if there is no outbound CID info. The rea-
not allowed in the User son for this is: the from and display portion
ID field). of the invite message would be blank, and
(ex. : UserID@Host- it would not know where the call originated
Name.DomainName) from.
0 = IP Address If the information from Telco was a domain
1 = Domain Name name (siptrunk@sip.com) then set to do-
main. If the information for Telco was a IP
address then set to IP Address.
0 = Disable Trunk port binding is only used for SIP
1 = Enable trunks to the provider in Non-Registration
Mode only. When this is disabled, an in-
bound call comes in and follows your DID
routing but it comes in on the first available
trunk. When enabled, the inbound call
comes in and follows your normal DID
routing but maps to that specified trunk. If
that trunk is busy, it sends back a busy un-
less you build a hunt group. To build the
hunt group, it references command
14-12-02 (pilot register ID). This then
points you to command 10-36-02. All the
numbers with the same pilot are in the
same hunt group.
1 ~ 2
Description
SL1100
Program
10
Default
No Setting
No Setting
0
No Setting
0
0
2-29