NEC SL1100 Programming Manual page 256

SL1100
Item
No.
07 Deny Restriction Table
This option lets you program the Restrict
Code Tables.
If the system has Toll Restriction enabled,
users cannot dial numbers listed in these ta-
bles.
There are four Restrict Code Tables, with up
to 60 entries in each table.
The system restricts calls exactly as you en-
ter the code.
08 PBX Access Code
Use this option to enter the PBX Access
Program
Code.
When the system is behind a PBX, this is the
code users dial to access a PBX trunk.
21 Toll Restriction begins after the PBX access
code.
For PBX trunks (Program 14-04) the system
only Toll Restricts calls that contain the ac-
cess code.
Always program this option when the system
is behind a PBX, even if you don't want to
use Toll Restriction.
PBX Access Codes can have up to two dig-
its, using 0-9, #,
care).
When using Account Codes, do not use an
asterisk in a PBX access code. Otherwise,
after the
the central office.
Entries 1~4 correspond to the 4 PBX Access
Codes.
Each code can have up to two digits.
09 Specific Dial Outgoing Code
10 Outgoing Call Code Setup
Conditions
None
Feature Cross Reference
None
2-236
Item
and LINE KEY 1 (don't
*
, the trunk stops sending digits to
*
Table Input Data
[caption: table] Dial (Up to 12 dig-
1 ~ 4 (table) its)
1 ~ 60 (Entry)
[caption: table] Dial (Up to two
1 ~ 4 digits)
[caption: table] Dial (Up to eight
1 ~ 20 digits)
[caption: table] Dial (Up to four
1 ~ 20 digits)
Program 21 : Outgoing Call Setup
ISSUE 6.0
Default
Tables 1 ~ 4 = No Setting
Tables 1 ~ 4 = No Setting
Tables 1 ~ 20 = No Set-
ting
Tables 1 ~ 20 = No Set-
ting