NEC SL1100 Programming Manual page 149

ISSUE 6.0
Item Item
No.
05 Transfer Key Op-
eration Mode
06 Hold Key Operat-
ing Mode
07 Automatic Hold
for CO Lines
08 Automatic
Handsfree
09 Auto answer to
incoming call
from Extension
10 Ringing Line
Preference for
Trunk Calls
11 Callback Auto-
matic Answer
12 Off-Hook Ringing 0 = Muted Off-Hook
13 Redial List Mode
15 Storage of Call-
er-ID for an-
swered call
16 Handsfree Oper-
ation
18 Power-Saving
Mode
Programming Manual
Input Data
0 = Transfer Use this option to set the operating
1 = Serial Call (call mode of the extension Transfer key.
back) The keys can be for Call Transfer,
2 = Flash Serial Calling or Flash. When select-
ing the Flash option (selection 2),
refer also to Program 81-01-14.
0 = Normal (Common) Use this option to set the function of
1 = Exclusive Hold the Multiline Hold key. The Hold key
can activate normal Hold or Exclu-
sive Hold.
0 = Hold When talking on a CO call and an-
1 = Disconnect (Cut) other CO line key is pressed, the
original trunk is placed on Hold (0)
or Disconnected (1).
0 = Preselect Use this option to set whether
1 = One-Touch (Auto- pressing a key access a One-Touch
matic Handsfree) Key or if it preselects the key.
0 = Off
1 = On
0 = Idle (Off) Use this option to select between
1 = Ringing (On) Idle and Ringing Line Preference for
trunk calls.
0 = Off Use this option to enable or disable
1 = On automatic answer of calls recalling
to a station. For example, if a Trans-
fer Recall or Hold Recall is ringing
back to a station, the following hap-
pens:
If Program 15-02-11 is enabled, the
station will automatically answer the
recall when it goes off-hook. If Pro-
gram 15-02-11 is disabled, a station
does not automatically answer the
recall when it goes off-hook. The
user must first press the line ap-
pearance of the recalling call or
press the answer key.
Use this option to set the telephone
Ringing Off-hook signaling. Off-hook signal-
1 = No Off-Hook Ring- ing occurs when a telephone user
ing receives a second call while busy on
3 = Beep in Speaker a handset call. To enable/disable
(SP) Off-hook signaling for an extension
4 = Beep in Handset Class of Service, use Program
(HS) 20-13-06.
5 = Speaker and Hand-
set Beep
0 = ICM/Trunk (Exten- Select whether the Redial List fea-
sion/Trunk Mode) ture should store internal and exter-
1 = Trunk Mode nal numbers (0), or only external
numbers (1).
0 = Disable (Off)
1 = Enable (On)
0 = Disable (Off) Enable or disable an extension abili-
1 = Enable (On) ty to use the speakerphone on out-
side calls. When disabled, users can
hear the conversation, but cannot
respond handsfree.
0 = Normal mode
1 = Power-Saving
Mode (Eco-Mode)
Description Default
SL1100
Related
Program
0
0
1
Program
15
1
1
1
1
5
0
1
1
1
2-129