Ars Dial Treatments - NEC SL1100 Programming Manual

SL1100
Level:
IN
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS
Program
dialing translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02. The
ARS Dial Treatment options are:
26
• An - For Alternate Carrier Access (n = 1 ~ 4). The numeric digit instructs the system to insert a
Transit Network Selection information element in the SETUP message and also identifies which
code in Program 26-11 will be included in the information element. This function is valid only for
outbound calls by ISDN trunks.
• DNN - Outdial the NN number of digits or execute the code that follows. For example, D041234
outdials 1234. Valid entries are 0 ~ 9, #,
counts as a digit. So, for example, if a P was added for a pause, the entry would look like :
D05P1234.
• Wnn - Wait nn seconds.
• P - Pause in analog trunk.
• R - Redial the initially dialed number, including any modifications.
• E - End of Dial Treatment. All Dial Treatments must end with the E code.
• X - When ARS is enabled, X must be entered in the Dial Treatment for the system to output the
extension number of the call originator to the black box for the E911 feature.
Input Data
Item
No.
01 Treatment Code
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
2-308
Dial Treatment Table Number
Item
Program 26 : ARS Service

26-03 : ARS Dial Treatments

, Wnn (wait nn seconds) and P (pause). Each digits code
*
Input Data
Maximum 36 characters
ISSUE 6.0
1 ~ 15
Default
No Setting
Program 26 : ARS Service