Switching The Se Server On - Fujitsu SE500 Basic Operating Manual

Switching the server on and off

8.1.2 Switching the SE server on

The following hardware components must be switched on in this order:
1. Switch on the optional hardware components
Switch on the ETERNUS LT40 S2 tape library using the On/Off switch at the front (see
Ê
the "Additive Components" Operating Manual [4]).
Switch on any other connected hardware components.
Ê
i
2. Switch on the MU
The power-on indicator (item 11 in
STAND-BY).
Switch on the rack console by pulling out and folding out the monitor, see
Ê
Press the On/Off switch on the MU (item 12 in
Ê
The power-on indicator lights up green. The MU switches itself on, conducts a system
test and starts the M2000 software. This takes a little time. Finally, on the rack console
you see the login window for the Linux desktop of the local console.
Call the SE Manager, e.g. after logging in on the local console via the browser of the
Ê
Linux desktop (in the "Computer" menu in the task bar) or via an administration PC
(default), see the "Operation and Administration" manual [5].
You can also switch on the MU remotely via the iRMC of the MU, see the "Operation and
Administration" manual [5].
U41858-J-Z126-2-76
The ETERNUS JX40 S2 disk storage system is switched on automatically on a
Server Unit when the Server Unit is switched on.
figure 10 on page 50) lights up orange (POWER
figure 10 on page
Switching the SE300 on and off
50).
page 33.
71