Fuel Pump - Arctic Cat 2015 ZR 5000 Service Manual

2. Disconnect the gasline hose from the fuel pump.
3. Remove the hose clamps and discard; then slowly
remove the fuel hoses from the fuel filter. Dispose of
the excess fuel from the filter properly.
 NOTE: Inspect the hoses for any signs of cracking,
cuts, or wear points. Replace if necessary.
INSTALLING
CAUTION
When installing the gasline hoses and clamps make
sure the hoses are pressed up against the filter and the
clamps are not installed over the end of the hose or the
barb on the filter.
1. Place new hose clamps on the gasline hoses; press
the gasline hoses onto the filter making sure they are
fully pressed on.
2. Secure the gasline hoses using the clamps making
sure
there is no more than 9 mm between the filter and
the clamps.
3. Use Fuel Hose Clamp Tool to make sure the fuel rail
side hose clamp is tight by crimping the clamps until
the two clamp areas touch.
SNO-700A
 NOTE: On the 9000, insert the filter making sure the
lip sits between the tab and clamp.
XM184B
4. Install the gas tank (9000), seat, and hood; then start
the engine and inspect the gasline hoses and filter for
any signs of leaks.
5. Secure the fuel filter to the fuel filter bracket; then
install both consoles and both access panels.
TESTING
1. Remove the seat(s); then remove the upper and lower
console panels.
2. On 7000 models, remove the torx screws securing
the fuel pump protector to the fuel tank assembly.

Fuel Pump

XM282
SNO-1021
YM-086A
125