Arctic Cat 2015 ZR 5000 Service Manual page 44

34. With the resonator properly installed to the chassis
support, install the spring securing the resonator to
the mounting tab.
 NOTE: With the exhaust system installed, connect
the oxygen sensor to the harness connector.
5000
9000
35. Install and secure the drive clutch with the cap screw
(lightly coated with oil); then tighten the cap screw
to 51 ft-lb.
CAUTION
When installing the drive clutch, do not tighten the
clutch cap screw with any kind of impact tool. Tighten
cap screw using a hand torque wrench only. Failure to
do so could result in stationary sheave damage.
36. Install the drive belt (see the Drive Train/Track/
Brake Systems section); then install and secure the
driven clutch (see the Drive Train/Track/Brake Sys-
tems section).
37. Connect the two harness connectors to the ECM;
then lock the fuse block into the bracket of the front
belt guard.
38. Install the gas tank (see the Fuel Systems section).
42
39. Install and secure the lower console to the skid plate
with the ¼ turn screws; then install the upper console
over the gas tank and install and tighten the retaining
nut to the neck of the gas tank.
PC024A
40. Connect the wires to the reverse alarm; then install
the two screws securing the console to the steering
PC241
bracket.
 NOTE: On the LXR/LTD models, connect the har-
ness connector to the seat heater switch before
securing the upper console.
41. Connect the battery cables (positive first) and the
ground wire to the battery; then connect the solenoid
harness to the solenoid.
 NOTE: On the LXR/LTD models, connect the seat
heater harness connector.
42. Install the seat (see the Steering and Body section).
43. Elevate the front of the snowmobile until the tunnel
heat exchangers are angled upward towards the
engine.
PC027A
0746-324
XM015A