Arctic Cat 2015 ZR 5000 Service Manual page 144

4. Remove the cap screws securing the harness clamp
to the magneto cover. Remove the three cap screws
securing the magneto to the cover; then remove the
magneto assembly.
INSTALLING (7000)
1. Place the magneto into position on the cover; then
install and tighten the three cap screws (threads
coated with blue Loctite #243) to 7.2 ft-lb. With the
harness routed properly, install the timing sensor and
harness clamp and tighten (threads coated with blue
Loctite #243) to 7.2 ft-lb.
 NOTE: Be sure to apply a small amount of sealant to
the grommet before pressing it into the cover.
142
YM-056A
2. Install the two alignment pins in the engine for the
magneto cover; then with a new gasket, install the
cover and with a crisscross pattern, tighten the
screws to 8.7 ft-lb.
YM-057A
 NOTE: The black screw (A) indicated by the black
arrow (B) must have blue Loctite #243 applied to the
threads. Tighten to 8.7 ft-lb.
3. Secure all coolant hoses and oil hoses using the
existing clamps; then secure the left-side support
using the existing cap screws and nuts. Tighten
YM-057A
securely.
SNO-380
YM-056
SNO-381A