Arctic Cat 2015 ZR 5000 Service Manual page 33

 NOTE: At this point, removing the front fascia will
aid in engine removal.
16. Remove the coolant return hose from the turbo-
charger; then remove the screws securing the front
heat shield to the chassis and rear heat shield.
17. Remove the cap screws (E) and (H) securing the side
supports; then remove the supports noting the posi-
tion of the cable ties and harnesses.
PC056A
 NOTE: On the 5000 before removing the MAG-side
support, the MAP sensor must be removed and the
cable ties securing the wire harness and vent hose
must be removed.
PC540A
18. Remove the cap screws and nuts securing the front
spars to the steering support; then remove the torx-
head screws securing the steering post bracket to the
steering support. Remove the steering support.
PC057A
19. Remove the cap screws (F) or (G) securing the shock
mounting bracket support to the shock mounting
brackets; then remove the cap screws (C) securing
the lower front spars to the shock mounting brackets.
Remove the shock mounting bracket support and
front spars accounting for the spar inserts.
 NOTE: On the 9000, the shock mounting bracket
support, left front spar, and heat shield are removed
PC058A
as an assembly.
746-292C
PC029A
PC030
31