Arctic Cat 2015 ZR 5000 Service Manual page 55

11. Remove the eighteen cap screws securing the mag-
neto cover to the engine; then remove the cover and
account for the starter torque limiter (A), spacer (B),
idler gear (D), inner spacer (C), and outer spacer (E).
 NOTE: Care must be taken when removing the mag-
neto cover not to tip the cover downward. Tipping the
cover downward will allow the starter torque limiter/
idler gear assembly to slide out of the cover.
12. Remove the four cap screws securing the oil scav-
enge pump to the engine; then remove the pump and
account for the remaining oil seal.
13. To remove the flywheel, first remove the cap screw
and washer securing the flywheel to the crankshaft;
then using Flywheel Puller, remove the flywheel.
ZJ031A
14. Remove the flywheel key from the crankshaft; then
remove the starter gear.
15. On the 5000, remove the cap screws securing the two
cylinder ignition coils to the cylinder head cover and
742-002A
remove the coils.
16. Remove the four cap screws securing the cylinder
head cover to the cylinder head; then remove the
cover.
ZJ033A
ZJ034
ZJ036A
ZJ049A
53