Arctic Cat 2015 ZR 5000 Service Manual page 124

6. Install the hose connecting the intake pipe to the
throttle body and secure with the hose clamps.
7. Install the coolant hoses to the throttle body and
secure with the clamps; then install the harness con-
nector to the throttle position sensor.
8. Install the harness connector to the idle speed control
(B); then install the throttle cable to the throttle body
pulley and secure the cable with the jam nut (A).
 NOTE: Make sure the throttle cable is secured cor-
rectly so the cable does not rub on the steering post.
 NOTE: Make sure the throttle lever free-play is
within a range of 0.030-0.060 in.
9. Install the gas tank and seat; then install the hood and
side panels. Connect the hood harness.
REMOVING/DISASSEMBLING (7000)
 NOTE: To remove the throttle body assembly, it is
necessary to remove the access panels, hood, air
intake assembly, and the two front spars.
1. Remove the coolant hoses and MAP sensor hoses
from the throttle body.
122
2. Disconnect the throttle body harness from the main
harness; then loosen the three screws securing the
throttle body to the intake boots.
TZ108A
3. Loosen the throttle cable jam nut; then remove the
throttle cable from the bracket and the throttle valve
cam. Remove the throttle body.
4. Remove the cable ties securing the throttle body har-
ness to the fuel rail.
SNO-741A
 NOTE: For installing purposes, note the location of
all cable ties.
5. Remove the screws and washers securing the fuel
rail to the throttle body; then remove the injectors.
Account for six O-rings.
YM-043A
YM-044A
YM-045A