Arctic Cat 2015 ZR 5000 Service Manual page 37

5000
9000
40. Raise the engine up and tip the engine forward
enough to remove the cables from the starter motor
and the rear engine/heat exchanger coolant hose.
 NOTE: At this time, verify all components connect-
ing the engine to the chassis are disconnected and
out of the way.
41. Raise the engine until the studs of the lower front
engine to chassis mount clear the chassis; then rotate
the engine clockwise enough to clear the PTO-side
engine to chassis mount and carefully lift the engine
up and out of the chassis.
PC037A
1. Carefully lower the engine into the chassis position-
ing the engine so it clears the PTO-side rear engine/
chassis mount and on the 9000, the turbocharger
clears the front of the chassis; then lower the engine
until the studs of the lower front engine/chassis
XM097A
mount are into the mounting holes of the chassis.
PC038A
2. Tip the engine forward enough to install the cables to
the starter motor and tighten the ground cable to 19
PC039A
ft-lb and the positive cable to 42 in.-lb.
Installing
PC040A
PC040A
PC047A
35