Arctic Cat 2015 ZR 5000 Service Manual page 168

8. If the bearing will be replaced, remove the snap ring;
then using a suitable press, remove the bearing from
the housing.
 NOTE: Never reuse bearings that have been
removed. Always use new bearings.
 NOTE: If the caliper housings were separated, they
must be secured together with the seal installed
between the inner and outer housings.
9. Position a piece of wood between the pistons. Using
low-pressure compressed air, blow into the caliper
brake hose fitting to loosen the brake pistons.
! WARNING
Always wear safety glasses when using compressed
air.
166
PC174
10. Remove the two screws securing the caliper halves.
Discard the seal.
PC148A
11. Remove the pistons (A) and O-rings (B); then dis-
PC200
card the O-rings.
PC221A
PC219A
PC173
PC220A