Arctic Cat 2015 ZR 5000 Service Manual page 83

22. Loosen the cap screws in decreasing numerical order
of the embossed numbers on the crankcase. Loosen
each bolt 1/4 of a turn at a time. After all screws are
loosened, remove the screws.
23. Remove and discard the nuts securing the connecting
rod caps to the connecting rods.
 NOTE: The indicator mark (A) on the connecting rod
cap will always point to the MAG end of the crank-
shaft.
 NOTE: Because the connecting rods and connect-
ing rod caps are unique, note the I.D. marks and keep
all associated parts together for assembling pur-
poses.
24. Remove the crankshaft and piston assembly from the
crankcase.
CAUTION
Pistons can be removed from the top side only.
25. Straighten the locking tabs securing the cap screws
securing the balancer shaft; then remove both cap
screws and both balancer weights.
 NOTE: To remove the cap screws (C), place a small
piece of wood (B) between the balancer weight (C)
and the crankcase.
YM-020A
SNO-281
26. Remove the snap ring securing the water pump drive
gear; then remove the gear and shaft and account for
a spacer and a bearing.
SNO-282A
Servicing Components
Thoroughly clean all non-electrical components in parts-
cleaning solvent; then remove any carbon buildup from
the cylinder head and piston dome.
Visually inspect all engine components for wear or dam-
age.
SNO-384A
SNO-383A
SNO-319
81