Arctic Cat 2015 ZR 5000 Service Manual page 157

 NOTE: If the driven shaft and driveshaft are going to
serviced, proceed to Cleaning and Inspecting Chain
Case. If bearings and chain or case assembly are to
be replaced, remove the driven clutch; then proceed
to step 12.
12. Remove the left-side chassis support.
13. On 5000 and 9000 models, remove the left and right
rear engine mount bolts (A); then remove the Allen-
head screw (B) and cap screw (C) securing the left
rear engine mount to the engine.
14. On 7000 models, once the cap screws and nuts secur-
ing the left-side chassis support are removed, care-
fully remove the support and driveshaft.
15. On 5000 and 9000 models, lift and support the
engine at the rear to allow the engine mount to clear
chassis.
 NOTE: A support can be cut from a wood block 6 1/
"
2 long and placed under the throttle bodies for sup-
port.
16. Remove the inner snap ring; then from the left side,
carefully remove the driven shaft assembly keeping
the bearing 90° to the shaft.
17. Remove the skid frame assembly.
18. Remove the brake cover and the left-side footrest.
 NOTE: DO NOT split the brake caliper unless neces-
sary service work is required.
19. Remove the cap screws securing the inner caliper to
XM091A the tunnel; then remove the inner caliper.
20. Pull the driveshaft out to the left; then drop out of
tunnel right side first.
YM-054
 NOTE: If the calliper does not remove from the
driveshaft easily, proceed to step 22.
21. Remove the brake pads; then remove the outer brake
caliper. Account for a rubber seal.
 NOTE: Place an absorbent towel under the caliper
to absorb slight amount of brake fluid. Do not com-
press the brake lever.
22. Remove the snap ring securing the brake disc to the
driveshaft and remove the brake disc.
 NOTE: It may be necessary to use Brake Caliper
Bearing Puller (p/n 0744-067) to remove the caliper/
bearing assembly.
23. If the chain case needs to be removed, remove all
self-tapping screws and machine screws with lock
nuts.
PC169A
PC163A
YM-077A
155