Arctic Cat 2015 ZR 5000 Service Manual page 190

6. Turn the slide rail onto the side the idler wheel was
installed in (from step 5); then with a block of wood
placed under the inner carriage axle/idler arm, install
a wave washer.
7. Install the remaining idler wheel along with the snap
ring onto the axle; then using a suitable driving tool,
carefully drive the snap ring into the idler wheel until
properly seated in the groove of the axle.
8. Grease the idler arm and rear arm grease fittings with
an all-temperature grease.
188
Rear Arm Assembly
REMOVING
1. Remove the skid frame; then remove the slide spring
from the adjusting cam.
Care must be taken when removing the spring or dam-
age or injury could result.
2. Mark the offset arm and the idler arm for assembly
XM002
purposes.
3. Loosen the cap screws and lock nuts securing the
offset arm assembly to the idler arm; then remove the
offset arm assembly. Account for a flanged axle,
idler spacer, and washer.
XM005
4. Remove the idler wheel.
 NOTE: Use the Idler Wheel Puller Kit to remove the
wheel.
5. Remove the cap screw, flat washer, and lock nut
securing the spring slide to the slide rail. Account for
the spring slide and all mounting hardware.
6. Remove the spring and sleeve from the idler arm.
 NOTE: Use the same procedure for the other side.
7. Remove the cap screw and lock nut securing the
upper shock eyelet to the idler arm; then remove the
cap screw and lock nut securing the upper shock link
to the idler arm. Account for the cap screws, lock
nuts, and sleeves.
XM001A
(Pantera)
! WARNING
YM-120
YM-121