Seat Cushion; Taillight/Brakelight Assembly - Arctic Cat 2015 ZR 5000 Service Manual

Hide thumbs Also See for 2015 ZR 5000:
Table of Contents

Advertisement

 NOTE: On models with heated seats prior to lower-
ing and securing the seat, connect the seat heater
harness connector.
PANTERA
1. Lift up both seat latches and hold them in that posi-
tion; then lift and remove the passenger seat. Make
sure to disconnect the accessory harness.
2. Release the lever securing the operator seat; then lift
up and remove the front seat. Make sure to discon-
nect the seat heater harness. Remove the operator
seat.
3. To install the operator seat, route the front tab on the
operator seat through the seat-base hold-down
bracket; then secure the rear of the operator seat
using the lever.
4. To install the passenger seat, position the front of the
seat base tabs under the loops in the seat frame; then
press down and secure using the two seat latches.
24
SNO-227A
NOTE: Be sure to connect the accessory harness.
RE MOVING
1. Remove the seat assembly.
2. Using a sharp tool, pry out all staples securing the
seat cover to the plastic seat base.
3. From beneath the seat foam, remove the seat wire
from the two elastic loops; then remove the cover
from the seat base and seat foam.
INSTALLING
1. Position the cover over the seat foam and seat base;
then pull the two elastic loops through the slots in the
seat foam and secure with the seat wire. Check to
make sure it is positioned straight.
2. Fold the rear edge of the cushion down and around
the plastic base. Using a staple gun and 1/4 in. sta-
ples, staple the rear flap of the cushion to the plastic
0748-449
base in the same areas as the original staples were
located. Position staples 1 in. apart.
3. Fold the sides of the cushion down around the bot-
tom edge of the plastic seat base. Position the staples
in the same area as the original staples were located.
 NOTE: Note the cushion fit. If any wrinkles are
noted, remove by pulling the cushion material in the
appropriate direction before securing with staples.
4. Fold the front cushion material back and onto the
plastic seat base. Check for wrinkles and secure with
staples and two screws.
5. Install the seat assembly.
Taillight/Brakelight
0748-419
ZR/XF/M
1. Remove the two machine screws securing the tail-
light to the taillight support; then disconnect the tail-
light harness connector.

Seat Cushion

Assembly
SNO-454A

Advertisement

Table of Contents
loading

Table of Contents