Arctic Cat 2015 ZR 5000 Service Manual page 159

12. Install the drive clutch and tighten the clutch cap
screw to 51 ft-lb; then install the driven clutch and
drive belt. Tighten to 20 ft-lb (threads coated with
blue Loctite #243).
13. With the driveshaft installed into the chain case,
install the existing thrust washer and secure with the
silver snap ring making sure it is fully seated into the
groove closest to the bearing.
14. Install the black snap ring into the groove on the
driveshaft making sure it is fully seated into the
groove; then install the thrust washer up against the
snap ring.
15. On 5000 and 9000 models, install the chain and
sprockets; then install the ratchet block making sure
to have the tensioner on the fifth notch.
 NOTE: On 7000 models, turn the chain tension
adjustment bolt clockwise until it is finger tight; then
loosen it 1 1/2 turns. While holding the bolt with a
wrench, tighten the jam nut to 18 ft-lb.
16. Secure the top sprocket using the existing thrust
washer and black snap ring making sure it is fully
seated into the groove.
YM-096
17. Before installing the reverse sprockets and chain, be
sure the reverse shaft and thrust washer are installed
into the chain case.
YM-098
18. Install the reverse sprockets and chain; then place the
existing thrust washer on the outside of the upper
reverse sprocket.
19. Secure the driveshaft reverse sprocket to the drive-
shaft with a snap ring; then install a existing thrust
washer on the outside of the upper reverse sprocket
and reverse idler shaft.
PC085A
YM-053
YM-097
YM-099
157