12. Install the inlet boot and the inlet hose and secure
using the existing clamps.
13. Secure the front left-side facia to the chassis using
the existing torx-head screws.
14. Secure the front heat shield using the existing torx-
head screws; then secure the coolant return hose (A).
15. Install the intercooler, air bypass valve, and the air
duct as an assembly into the four mounting brackets.
16. Secure the outlet hose, air duct, and intercooler using
the existing clamps (A); then install the air filter (B)
and all hoses connected to the intercooler.
SNO-232A
17. Connect the oxygen sensor; then install the cap
screws, nuts, new gasket, and spring securing the
resonator to the chassis.
SNO-233
NOTE: Check the coolant level and the oil level. Add
as necessary (see the Fuel Systems section).
18. Install the right- and left-side panels; then install the
hood.
PC229A
SNO-231A
PC227
113