Ski Alignment - Arctic Cat 2015 ZR 5000 Service Manual

2. Place the steering tie rod into position on the steering
post. Secure with a new nyloc nut. Tighten to 35 ft-
lb.
 NOTE: Make sure the tie rod tab is fully seated into
the steering post and threads of the ball joint are
above the nut when tightened correctly.
3. Place the tie rod end into position on the steering tie
rod bracket. Secure with a new nyloc nut. Tighten to
20 ft-lb.
4. Slide the steering tie rod through the steering boot
and into the snowmobile; then place the steering tie
rod into the spindle arm with the washer. Secure
with a new nyloc nut. Tighten to 32 ft-lb.
5. Secure the steering tie rod to the steering tie rod
bracket with the screw and new nyloc nut. Tighten to
20 ft-lb.
20

Ski Alignment

SNO-351
CHECKING
 NOTE: Track tension and alignment must be prop-
erly adjusted prior to checking or adjusting ski align-
ment. Ski alignment must be performed on a flat,
level surface. Ski toe-out must fall within the range of
1/16-1/4 in.
1. Raise the front end of snowmobile just high enough
to keep the skis from contacting the floor.
2. Turn the handlebar to the straight-ahead position.
Visually inspect the handlebar for being centered and
in the straight-ahead position.
3. With the handlebar in the straight-ahead position,
secure the handlebar to prevent the alignment from
becoming disturbed during the remainder of the
alignment procedure.
 NOTE: Track tension and alignment must be prop-
erly adjusted prior to placing the straightedge against
the outside edge of the track.
SNO-350
4. Place a long straightedge against the outside edge of
the track so it lies near the inside edge of the left-side
ski.
 NOTE: The straightedge should be long enough to
extend from the back of the track to the front of the
ski.
5. Measure the distance from the straightedge to the
left-side ski wear bar bolts in two places: approxi-
mately 7-8 in. in front of the spindle and 7-8 in.
behind the spindle. Record the measurements taken
for the left side.
SNO-353
SNO-349
729-887A