Arctic Cat 2015 ZR 5000 Service Manual page 36

32. Remove the two cap screws securing the elbow fit-
ting of the oil supply hose to the engine; then secure
the hose and fitting up and out of the way.
 NOTE: On the 5000, install Engine Lift Plate. On the
9000, secure a suitable length of chain of adequate
strength to each side of the cylinder head with two 10
mm cap screws threaded through the mounting hole
of the cylinder head.
5000
34
9000
PC243
 NOTE: Before removing the mounting hardware
securing the engine to the chassis, remove the
weight of the engine from the chassis using a suit-
able lift or hoist.
33. On the 9000, remove the front bumper.
34. Remove the front belly pan cap screws; then remove
the belly pan. Remove the cap screws securing the
access panel to the chassis; then remove the access
panel.
35. Remove the two lock nuts securing the front engine
mount to the chassis.
36. Remove the cap screws securing the MAG-side rear
engine to chassis mount; then remove the mount.
37. Remove the screw securing the front belt guard to
the skid plate, then remove the cap screws, lock nuts,
PC036A
and carriage bolt securing the PTO-side chassis sup-
port. With the fuse block out of the bracket, remove
the support with the front belt guard.
 NOTE: After removing the PTO-side chassis sup-
port, re-install the cap screw securing the rear PTO-
side engine to chassis mount (bearing bracket) to
secure the bearing.
0746-313
38. Remove the cap screws securing the PTO-side
engine to chassis mount (bearing bracket).
39. Disconnect the harness connectors from the regula-
tor/rectifier and magneto; then remove the cap
screws securing the routing clamp to the engine
(5000 models) and secure the wire harness up and
out of the way.
0746-314
PC209A