Arctic Cat 2015 ZR 5000 Service Manual page 95

33. Install the existing dowel pins into the cylinder head;
then install the intake and exhaust camshaft caps.
Tighten the camshaft cap screws to 86 in.-lb in two
stages and in a crisscross pattern working from the
inner caps out.
 NOTE: The "I" mark refers to the intake camshaft
caps and the "E" mark refers to the exhaust camshaft
caps. Install the camshaft caps with the arrow mark a
pointing towards the MAG side of the engine. Make
sure the holes (B) in the camshaft are aligned with
the arrow mark (A) on the camshaft caps.
CAUTION
Lubricate the camshaft cap screws with engine oil. The
camshaft cap screws must be tightened evenly or dam-
age to the cylinder head, camshaft caps, and camshafts
will result. Do not turn the crankshaft when installing
the camshaft to avoid damage or improper valve timing.
34. Squeeze the timing chain tensioner clip (A); then
push the timing chain tensioner rod (B) into the tim-
ing chain tensioner housing. Do not release the tim-
ing chain tensioner clip while pushing the rod into
the housing or the rod may be ejected.
SNO-311A
35. With the tensioner rod compressed, flip the hook (A)
over the rod (B) to secure it down.
36. Install the chain tensioner assembly and secure using
the existing allen-head screws. Tighten to 104 in.-lb.
 NOTE: Be sure to install the timing chain tensioner
gasket so its section with the "L" mark is protruding
from the lower left side of the timing chain tensioner.
The arrow mark (A) on the timing chain tensioner
should face up.
SNO-283A
37. Apply Three Bond Sealant onto the mating surfaces
of the cylinder head cover and cylinder head cover
gasket.
SNO-312A
SNO-313A
SNO-315A
93