Electric Fuel Pump/Fuel Level Sensor - Arctic Cat PROWLER XT 2014 Service Manual

 NOTE: Always use a large container and have suffi-
cient floor drying material available when draining
the coolant in case of coolant spillage.
2. Remove the coolant hoses from the water pump; then
remove two cap screws securing the water pump to
the crankcase.
3. Remove the water pump from the engine.
INSTALLING
1. Install a new O-ring onto the water pump and lightly
coat with clean engine oil.
2. Install the water pump assembly onto the engine
aligning the flat drive on the water pump to the slot
in the driven gear shaft.
CAUTION
Do not force the water pump housing into the crankcase
or sever engine damage may occur.
3. Secure the water pump with the two cap screws and
tighten securely; then connect the coolant hoses and
secure with hose clamps.
4. Tighten the coolant drain plug securely; then fill the
cooling system with appropriate mixed coolant and
install the radiator cap.
5. Start the engine and check for coolant leaks; then add
coolant if necessary to proper level.
After operating the vehicle for the initial 5-10 minutes,
stop the engine, allow the engine to cool down, and
check the coolant level. Add coolant as necessary.
Electric Fuel Pump/Fuel
Level Sensor
GZ230A
The electric fuel pump and fuel level sensor are not ser-
viceable components. If either component fails, it must
be replaced.
TESTING
Whenever any maintenance or inspection is made on
the fuel system during which there may be fuel leakage,
there should be no welding, smoking, open flames, etc.,
in the area.

Prior to removing the electric fuel pump, the following
check should be performed to determine that removal
is necessary.
1. Turn the ignition switch ON and listen for a momen-
tary "whirring" sound of the pump building pressure.
If the sound is heard (10 seconds), no electrical
checks are necessary. Turn the ignition switch OFF.
GZ252C
2. Disconnect the gasline hose from the fuel rail; then
install a suitable pressure gauge.
Gasoline may be under pressure. Place an absorbent
towel under the connector to absorb any gasoline spray
when disconnecting.
GZ252D
CAUTION
! WARNING
AT THIS POINT
! WARNING
FI092A
155