Arctic Cat 2015 ZR 5000 Service Manual page 49

2. Carefully lower the engine into the chassis aligning
the rear engine mounts with the chassis mounts; then
loosely secure using the existing cap screws and
nuts.
3. Loosely secure the front engine mounting bracket to
the chassis using the existing cap screws and nuts;
then loosely secure the ground cable to the engine
using the existing cap screw and nut.
4. Tighten the rear engine cap screws and nuts to 93 ft-
lb.
5. Tighten the cap screws (A and B) to 25 ft-lb. Tighten
cap screws (C) to 65 ft-lb. Tighten cap screw (D) to
30 ft-lb.
SNO-365
6. Connect the PTO-side coolant hose to the heat
exchanger using the existing clamps; then connect
the oil pressure switch, oil pressure sensor, and the
crankshaft sensor to the main harness. Tighten cool-
ant hose clamps to 30 in.-lb.
 NOTE: All wires must be installed on the inside of
the PTO-side coolant hose.
Make sure the top clamp is routed as shown so the
clamp does not come in contact with the drive clutch.
YM-039
 NOTE: Route the positive and negative battery
cables up and over the rear engine mounts.
7. Secure the upper mounting bracket, right-side chas-
sis support, and the right-side steering support to the
chassis using the existing cap screws and nuts.
Tighten to 20 ft-lb. Install the oil hose to the right
side of the engine.
SNO-364
CAUTION
SNO-364A
YM-066A
YM-038A
47