Arctic Cat 2015 ZR 5000 Service Manual page 93

 NOTE: If a cap screw is tightened more than the
specified angle, do not loosen the bolt and then
retighten it. Instead, replace the bolt with a new one
and perform the procedure again.
 NOTE: Do not use a torque wrench to tighten the
bolt to the specified angle.
19. Tighten cap screws 9-24 in order of the embossed
numbers on the crankcase. Tighten cap screws 9-12
to 17 ft-lb and cap screws 13-24 to 104 in.-lb.
 NOTE: After the tightening sequence, rotate the
crankshaft one revolution to verify free movement.
20. Place the dowel pins in place; then position the oil
pump assembly on the crankcase and secure using
the existing cap screws. Tighten to 11 ft-lb.
 NOTE: At this time, install the timing chain around
the crankshaft as it must go on before the oil pump
chain.
21. Position the oil pump chain around the crankshaft;
then install the oil pump driven gear and secure using
the existing cap screw. Tighten to 11ft-lb.
 NOTE: Install the oil pump driven gear with the
stamped mark "4XV" facing towards the oil pump
assembly.
SNO-304
22. With a new gasket and the existing dowel pins in
place, install the oil pan and install the different-
length cap screws. Using the pattern shown, tighten
the screws to 86 in.-lb.
YM-020A
 NOTE: If the oil pan drain plug was removed, always
install new drain plug and reservoir washers.
 NOTE: At this time, rotate the engine to the upright
position.
23. Secure the rear mounting brackets to the engine case
making sure the numbers on the brackets match the
numbers on the case. Tighten to 18 ft-lb.
YM-019
SNO-305
SNO-306
91