Arctic Cat 2015 ZR 5000 Service Manual page 28

7. Loosen the two side headlight assembly screws (A);
then remove the two front headlight assembly screws
(B).
8. Remove the headlight assembly.
REMOVING (7000)
1. Remove and retain all machine screws securing the
hood; then disconnect the console harness and
remove the hood assembly.
2. Remove the eight screws securing the windshield to
the console; then remove the windshield.
3. Remove the four screws securing the console.
26
PC108
4. Disconnect the gauge, electrical accessory wires, and
the ignition switch.
5. Remove the two screws securing the rear of the con-
sole to the hood (on the underside of the hood).
6. Loosen the two side headlight assembly screws; then
remove the two front headlight assembly screws.
PC106A
7. Remove the headlight assembly.
INSTALLING
1. With the headlight assembly in position, install the
front headlight assembly screws. Engage the side
headlight screws in the slots and tighten until snug.
2. Engage the side console tabs on the headlight assem-
bly; then place the front of the console over the head-
light assembly and press down until it snaps in place.
PC107A
3. Install the two screws securing the rear of the con-
sole to the hood. Tighten only until snug.
4. Place the windshield brace assembly into position
and secure to the console with the four screws.
Tighten until snug.
5. Connect the gauge; then connect the electrical acces-
sory wires and the ignition switch.
6. With the windshield in position, secure the wind-
shield to the frame using the four screws. Tighten
securely.
7. Connect the console harness; then install the hood
assembly and secure with the screws.
YM-028A
YM-029A