Arctic Cat 2015 ZR 5000 Service Manual page 39

9. Secure the PTO-side chassis support to the chassis
using the cap screws (I), carriage bolt (K), and lock
nuts (J). Tighten the cap screws to 25 ft-lb and the
carriage bolt and lock nuts to 12 ft-lb.
 NOTE: It may be necessary to pry against the back-
side of the carriage bolt until the nut becomes snug.
10. With the engine installed, remove the hardware used
to remove and install the engine.
11. Install the screw securing the front belt guard to the
skid plate.
12. Install the oil supply elbow fitting and cap screws to
the engine and tighten the cap screws to 96 in.-lb;
then install and secure the oil return hose and oil
breather hose to the engine.
 NOTE: Make sure the O-rings are in place before
installing the oil hoses.
13. Install the coolant/oil separator tank to the bracket on
the engine; then install the hoses with clamps to the
coolant/oil separator tank and secure the clamps.
PC210A
14. Connect the harness connectors to the regulator/rec-
tifier and magneto and with the harness properly
routed, secure the harness to the engine with cap
screw and routing clamp; then tighten the cap screw
securely.
5000
PC036A
9000
PC243
 NOTE: Steps 15-17 are for the 5000 only.
PC032B
PC025
PC037A
XM097A
37