Arctic Cat 2015 ZR 5000 Service Manual page 47

11. After the oil has drained completely, install a new
drain plug with a new O-ring and tighten to 16 ft-lb.
12. Using a suitable vacuum pump, remove the coolant
from the coolant filler neck and the reservoir tank.
13. Remove the screws securing the exhaust heat shield
to the tunnel, then remove the screw and nut securing
the shield to the right-side support. Account for two
mounting plates and two washers.
14. Remove the cap screws securing the exhaust pipe
assembly to the engine. Remove the assembly and
account for a gasket.
15. Loosen both clamps securing the coolant hoses to the
filler neck and the lower radiator connection; then
remove the two screws and the hold down bracket
securing the air intake to the radiator. Disconnect the
cooling fan and remove the radiator assembly.
16. Remove the fuse block from the coolant tank and
move it out of the way; then remove the screws
securing the right- and left-side facia to the chassis.
17. Loosen all three hose clamps securing the intake
boots to the throttle body; then disconnect the air
temperature sensor and remove the two screws
securing the front of the air intake to the chassis.
Remove the air intake assembly.
YM-024A
18. Remove the steering post assembly from the chassis
and from the steering support.
19. Remove all four cap screws securing the front spars
to the steering support and the front shock mount.
YM-034
20. Remove the two cap screws securing the right side
support to the steering support. Remove the steering
support.
21. Disconnect the throttle body harness from the main
harness; then remove the three clamps securing the
throttle body to the intake boots. Remove both cool-
ant hoses. Remove the throttle body.
YM-035A
YM-036
0747-939
YM-037A
45