Arctic Cat 2015 ZR 5000 Service Manual page 121

2. Loosen the throttle cable jam nut; then remove the
throttle cable from the bracket and the throttle valve
cam.
3. Remove the cable ties securing the fuel injector wir-
ing harness to the fuel rail; then disconnect the har-
ness from the fuel injectors.
 NOTE: For installing purposes, note the location of
all cable ties.
4. Loosen the clamps securing the throttle bodies to the
intake boots; then remove the throttle body assembly.
5. Remove the retaining clips securing the fuel rail to
the injectors; then remove the two screws securing
the fuel rail to the throttle body assembly. Remove
the fuel rail and injectors from the throttle body
assembly.
 NOTE: For assembling purposes, note from which
side the fuel injectors were removed.
ASSEMBLING/INSTALLING (5000)
1. Install the fuel injectors onto the throttle body assem-
bly; then secure the fuel rail and injectors to the
throttle body assembly with the two screws and the
retaining clips.
ZJ289A
ZJ103A
2. Install the throttle body assembly to the intake boots
and tighten the clamps; then install the coolant hoses
and the MAP sensor hoses. Secure the coolant hoses
with the clamps.
3. Connect the injector wiring harness to the injectors;
then secure the harness to the fuel rail with cable ties
in the proper locations as noted during disassem-
bling.
4. Install the throttle cable to the bracket on the throttle
body assembly and to the throttle valve cam; then
secure the cable with the jam nut.
ZJ290
 NOTE: To finalize this procedure, install the air
silencer. Install the gas tank and seat.
ZJ291A
ZJ290
ZJ103A
119