Arctic Cat 2015 ZR 5000 Service Manual page 34

20. Remove the MAG-side chassis support. Account for
and note the location and orientation of the resonator
spring tab and resonator support bracket.
21. Clamp off the coolant bypass hose and remove the
hose from the water pump; then add a length of hose
to the bypass hose and route the hose out of the
exhaust opening of the skid plate. Drain the remain-
ing coolant.
22. Remove the throttle body coolant hoses.
32
9000
23. Disconnect the harness connectors from the coolant
temperature sensor (A), oil pressure switch (B), and
air pressure sensor (C).
PC210A
24. Loosen the clamps and remove the drain and vent
hoses and the throttle body coolant hose from the
coolant/oil separator tank; then remove the tank from
the bracket on the engine.
PC026A
5000
 NOTE: Steps 25-27 are for the 5000 only.
ZJ018
25. Loosen the clamps securing the air silencer to the
throttle bodies; then disconnect the harness connec-
tor from the air temperature sensor and remove the
air silencer.
PC211A
PC028A
PC032