Arctic Cat 2015 ZR 5000 Service Manual page 162

 NOTE: Prior to installing the sprockets onto the
driveshaft, lightly chamfer the inside edge of the
sprocket to avoid binding.
1. Properly align the scribed line (B) on the driveshaft
(from removing) with the timing arrow on the drive
sprocket; then slide the sprocket onto the driveshaft
as far as it will go.
2. Using a suitable press and fixture, press the drive-
shaft into the sprocket until it aligns with the line
scribed in removing.
3. Slide the remaining sprocket onto the driveshaft
making sure the timing arrow/lines (from removing)
are aligned; then using the press/fixture, press the
sprocket to the remaining alignment line.
CAUTION
Always press against the tension-collar of the drive
sprockets or damage to the components will occur.
 NOTE: When pressing new sprockets on the drive-
shaft, align the sprocket alignment marks or the
sprockets won't be timed correctly.
160
4. Using a calipers, measure distances between the
sprockets and from the sprockets to each end of the
driveshaft for proper location (see appropriate illus-
tration).
XF 7000 LXR/Sno Pro/LTD
ZR 7000 LXR/Sno Pro/Sno Pro LTD/
Pantera
YM-075B
XF 9000 LXR/Sno Pro/Sno Pro LTD
ZR 9000, ZR 5000
M/XF 9000 CT/HC/CC
YM-071A
XF 7000 CC/CT
YM-072A
0747-963
0747-961
0747-960
0747-964