Arctic Cat 2015 ZR 5000 Service Manual page 81

11. Remove the four cap screws securing the output
shaft assembly to the crankcase; then thread the drive
clutch bolt into the end of the crankshaft and pull the
output shaft assembly from the engine.
12. Remove the Allen-head screws securing the water
pump assembly to the crankcase; then remove the
assembly. Account for two dowel pins and two gas-
kets.
13. Remove the five Allen-head screws securing the oil
cooler assembly to the engine. Remove the assembly.
14. Remove the two Allen-head screws securing the
chain tensioner to the cylinder assembly. Remove the
tensioner and gasket.
YM-009
15. Remove the cap screws securing the camshaft covers
to the cylinder head; then remove the covers.
Remove both camshafts. Account for twelve dowel
pins.
SNO-278
 NOTE: Keep each camshaft cover with the appropri-
ate camshaft for installation purposes. The "I" mark
refers to the intake camshaft caps and the "E" mark
refers to the exhaust camshaft caps. The camshaft
caps with the arrow mark (A) will always point to the
MAG side of the engine. Make sure the holes (B) in
the camshafts are aligned with the arrow mark (A) on
YM-011A
the camshaft caps.
YM-012
YM-013
YM-014
79