Honda 2002 Accord Manual page 630

Automatic Transmission
Transmission Installation (cont'd)
8. Face the dot mark (A) on the breather tube (B) up.
E
1 0 x 1 . 2 5 m m
3 8 N m (3.9 k g f m , 2 8 I b f f t )
9. Install the transmission mount bracket (C). Tighten
the bolt (D) loosely, and tighten the nuts (E) to the
specified torque, then tighten the bolt to the
specified torque.
10. Remove the transmission jack and hoist bracket.
11. Attach the torque converter to the drive plate (A)
with eight bolts (B). Rotate the crankshaft pulley as
necessary to tighten the bolts to 1/2 of the specified
torque, then to the final torque, in a crisscross
pattern. After tightening the last bolt, check that the
crankshaft rotates freely.
6 x 1.0 m m
10 N m (1.0 k g f m , 7.2 I b f f t )
6 x 1 . 0 m m \
1 2 N m (1.2 k g f - m , 8.7 I b f f t )
6 x 1.0 m m
1 4 N m (1.4 k g f m , 10 Ibf ft)
12. Tighten the crankshaft pulley bolt as necessary (see
page 6-18).
13. Install the control lever (C) with the shift cable (D)
on the control shaft (E). Do not bend the shift cable
excessively.
14. Install the lock bolt (F) with a new lock washer (G),
then bend the lock washer tab against the bolt.
15. Install the engine stiffener (H).
16. Install the shift cable cover (I), then install the shift
cable holder (J) on the shift cable cover.
NOTE: To prevent damage to the control lever joint,
be sure to install the shift cable holder after
installing the shift cable cover to the torque
converter housing.
14-120