Output Function; Output Range - NF DP015S Instruction Manual

10. Specifications
The following settings and conditions are provided, unless otherwise noted.
Load
Signal source
Output voltage waveform
Remote sensing
AGC/Autocal
Current Limiter
Output terminal
[set] indicates a setting value, and [rdg] indicates a read value.
The description noted with "/" indicates that the specification changes by the output range, such as
"100 V range specification/200 V range specification."
A value with the accuracy is the guaranteed value of the specification. However, an accuracy noted
as reference value shows the supplemental data for reference when the product is used, and is not
under the guarantee. A value without the accuracy is the nominal value or representative value
(shown as typ.).
The DP series, other than single-phase three-wire models (DP030D, DP060D, DP090D, DP120D),
corresponds to Clause 2 (8) Frequency converter, Appendix 1 of Export Trade Control Ordinance.
The permission for exportation of the Japanese Administration is necessary for export outside Japan.
10.1

Output Function

Output Function
10.2

Output Range

Output Range
242
Resistance load of power factor 1
INT (internal signal source)
Sine wave
Off
Off
Factory default setting
Rear panel output terminal block
Continuous, Sequence (optional), Simulation (optional)
All models
All models
100 V range, 200 V range
PROGRAMMABLE AC POWER SOURCE