Waveform Monitor Output - NF DP015S Instruction Manual

10. Specifications

10.29 Waveform Monitor Output

This can monitor the waveform of the output voltage or current. (only one terminal)
Monitored
Gain Phase
voltage
Phase
current
Accuracy
Output terminal
Output
impedance
Monitored
Gain Phase
voltage
Phase
current
Accuracy
output terminal
Output
impedance
Note: If you increased or decreased the number of units by the power unit energization setting, the
gain corresponding to the capacity is used for the current monitor. (Example: In the case that
only 3 units operate in 6 kVA model, the current gain of 4.5 kVA model is used. However,
in 7.5 kVA or higher model, the current gain of 6.0 kVA model is used for 4.5 kVA output,
and the one of 3.0 kVA model is used for 1.5 kVA output.)
268
Single-phase model, Polyphase model, Multi-phase model
015S,030D,045T 030S,060D,090T
045M (polyphase 090M (polyphase
output)
Output phase voltage or output phase current (switched)
1 1
/
50 25
(no load on the monitor output, the rated output voltage, the resistance load at
BNC connector (rear panel, unbalanced)
Single-phase model and Single-phase output of Multi-phase model
075S
Output phase voltage or output phase current (switched)
1 1
/
300 150
(no load on the monitor output, the rated output voltage, the resistance load at
BNC connector (rear panel, unbalanced)
(single-phase
output)
1 1
/
200 400
1 1
/
100 50 150
±5%
the maximum current)
600 Ω
090S, 090M
1 1
/
200 400
±5%
the maximum current)
600 Ω
PROGRAMMABLE AC POWER SOURCE
045S
060S
045M
090D, 120D
output)
1 1 1
/
75 200
105S 120S
1 1
/
400 200
1
/
100