Figure 4-11 Simulation Function Steps; Table 4-5 Simulation Function Steps And Settable Step Parameters - NF DP015S Instruction Manual

 Relationship between each step and settable Step parameters
V1, F1
Normal1
Trigger output
トリガ出力
Sync output
同期出力

Table 4-5 Simulation Function Steps and Settable Step Parameters

Step
Step time
AC voltage
Frequency
ON/OFF
Start phase
ON/OFF
Stop Phase
Trigger output
Sync code
output
Note: "—" means that this parameter cannot be set.
 Start phase (Start Phs)
ON or OFF can be selected for the start phase. When ON is selected, the step starts at the specified
start phase. When OFF is selected, the step starts at the phase in which the previous step ended.
When selecting ON, a numerical entry box in which you can specify the start phase opens.
The start phase can be set at the Normal 1, Normal 2, and Abnormal steps. For other steps, the start
phase is fixed to OFF and cannot be specified.
 Stop phase (Stop Phs)
ON or OFF can be selected for the stop phase. When ON is selected, the step ends at the specified
stop phase. If the phase is not the specified stop phase after the Step Time elapsed, the execution
continues the output of that step until reaching the specified Stop Phase, then performs the next step.
When OFF is selected, the step transitions to the next step when the Step Time has elapsed
regardless of the phase. When selecting ON, a numerical entry box in which you can specify the stop
DP Series
Trans1
移行1
定常1
T1 T2
S1
S2

Figure 4-11 Simulation Function Steps

Initial Normal 1
— T1
V0 V1
F0 F1
ON/OFF
P0 P1
ON/OFF
Q0 Q1
— ON/OFF
S0 S1
4.3 Using Power Fluctuation Testing (Simulation) Function
V3, F3
Abnormal Trans2
異常 移行2
T3 T4
S3 S4
Trans 1 Abnormal
T2 T3
— V3
— F3
ON/OFF
—
P3
ON/OFF
—
Q3
ON/OFF ON/OFF
S2 S3
V1, F1
Voltage and
電圧・周波数は
正常1と同じ
frequency are
same as
Normal 1
Normal2
定常2
T5
S5
Trans 2 Normal 2
T4 T5
— —(=V1)
— —(=F1)
ON/OFF
—
P5
ON/OFF
—
Q5
ON/OFF ON/OFF
S4 S5
105