Screen Configuration; Figure 5-1 Component Name (Display Areas On The Screen); Table 5-1 Component Name (Display Areas On The Screen) - NF DP015S Instruction Manual

5. Description of Screen and Menu
5.1

Screen Configuration

Figure 5–1 shows the basic screen configuration. It consists of display areas marked as "a" to "h".
The description of each area is shown in Table 5-1.
a
e
f
g
h

Figure 5-1 Component Name (Display Areas on the Screen)

Table 5-1 Component Name (Display Areas on the Screen)

Symbol Area name
a Screen title
b Output range
c Output mode
d Output phase
mode
e Status icon
f Measured value
area
g Output display
area
h Soft-key
function
i Window
198
b c d
Title of the currently displayed screen.
Current output range.
Current output mode. It is displayed in the format of
"AC/DC mode - Signal source."
Current output phase mode in the system.
1P2W: Single-phase two-wire/1P3W: Single-phase
three-wire/3P4W: Three-phase four-wire
The area where an icon is displayed when the product
enters the specific state, for example, when the limiter is
activated.
The measured values are displayed. In the Simple View,
three items are enlarged.
The output setting is displayed. Make the output settings
in this area.
Shows the functions assigned to the soft-keys below.
The window where the confirmation message is
displayed or you change the settings. It is displayed as
needed.
i
Description
PROGRAMMABLE AC POWER SOURCE
Refer
to
—
3.4.2
3.4.1
1.2
5.1.1
3.4.10,
3.4.11
3.4
3.3.3
3.3.4