Using The Emission Co Calculator; Using The Emission Co2 Calculator - NF DP015S Instruction Manual

2. In the [PwON Output] item, select [2:ON] or [1:OFF]. When you select [ON], the automatic
output-on at power-on is enabled.
4.23 Using the Emission CO
This is the function for calculating and displaying the weight of the carbon dioxide (CO
based on the measured value of the internal loss or the output power of this product. Following two
measuring modes are available: Instantaneous (Unit: kgCO
can change the coefficient for the calculation. For the specification of the emission CO
see 10.11.
-------- Notes----------------------------------------------------------------------------------------------------------------
 In the polyphase system, the emission CO
each cabinet.
 The emission coefficient (see 4.28) is not restored to the factory default setting even if you
reset this product. To restore the emission coefficient to the factory default setting, follow the
procedure below. For the default setting value, see 10.11.
---------------------------------------------------------------------------------------------------------------------------------
 Operation procedure
1. Press the [Measure] soft-key and select [3:CO
DP Series
4.23 Using the Emission CO
Calculator
2
/h) and Integration (Unit: tCO
2
of the cabinet is displayed on the LCD panel of
2
View]. The [CO
2
2
) emission
2
2
View] window opens.
2
Calculator
). Users
2
calculator,
187