Figure 4-24 Sensing Input Terminals In Multi-Phase Model - NF DP015S Instruction Manual

4. Advanced Operation
Connect the sensing input terminal to the output voltage detecting end (for example, load end) using
a cable. In the Multi-phase model, the sensing input terminal is common to each output phase mode
(single-phase two-wire, single-phase three-wire, and three-phase four-wire). The terminals to be
used for each output phase mode are shown in Figure 4–24. Do not connect anything to the terminals
that are not used.
Used for the single-phase two-wire output
Used for the single-phase three-wire output
Used for the three-phase four-wire output

Figure 4-24 Sensing Input Terminals in Multi-phase Model

 Turning on/off Remote sensing function
1. Press the [Measure] soft-key, then select [2: Measure].
158
単相2線出力で使用
単相3線出力で使用
三相4線出力で使用
PROGRAMMABLE AC POWER SOURCE