Remote Sensing - NF DP015S Instruction Manual

Voltage setting limit 2 (other than Voltage setting limit 1, phase voltage setting only)
Positive Setting Range
(Peak value)
voltage
Factory
default
Negative Setting Range
(Peak value)
voltage
Factory
default
Resolution
Note: The limitation is applied to the additional values of the AC voltage setting (recalculated to a
peak value) and the DC voltage setting.
Frequency setting limit (the lower limit ≤ the upper limit)
Upper Setting Range
limit
Factory default
Lower Setting Range
limit
Factory default
Resolution
Note: In the AC mode, the setting range is 40.0 Hz to 550.0 Hz.

10.15 Remote Sensing

This switches the voltage used for measurement. When the remote sensing is on, the sensing input
terminal voltage is used. When it is off, the output terminal voltage is used.
By combining with AGC or Autocal, a voltage drop due to wiring to the load can be compensated.
When the remote sensing is on, the output voltage detection point corrected by the AGC or Autocal
function is switched to the sensing input terminal. When AGC or Autocal is off, only the detection
voltage used for measurement display is switched.
Effective only for AC-INT, AC-VCA, AC-SYNC, DC-INT, and DC-VCA and when the waveform
is sine wave or DC. It is turned off when the Sequence or Simulation is selected.
voltage, power, power factor
On Use the sensing input terminal voltage
Off Use the output terminal voltage
DP Series
+10.0 V to +220.0 V / +20.0 V to +440.0 V
−220.0 V to −10.0 V / −440.0 V to −20.0 V
Measurement
All models
+220.0 V / +440.0 V
−220.0 V / −440.0 V
0.1 V
All models
1.0 Hz (AC mode : 40 Hz) to 550.0 Hz
550.0 Hz
1.0 Hz (AC mode : 40 Hz) to 550.0 Hz
1.0 Hz (AC mode : 40 Hz)
0.1 Hz
AGC/Autocal
Off
Not active
Not active (factory
default)
10.15 Remote Sensing
On
Active
Active
257