3. Basic Operation
-------- Notes----------------------------------------------------------------------------------------------------------------
Set the RMS values for the voltages of the sine wave (SIN) and the clipped sine wave (CLP)
and the Peak-to-Peak value for the voltage of the arbitrary waveform (ARB).
---------------------------------------------------------------------------------------------------------------------------------
Operation procedures for setting the DC voltage
1. Select the [DCV] item and then enter a numeric value. For how to enter values, see 3.3.5.
3.4.5 Setting the Output Voltage (Polyphase Output)
This section describes the operations in the balanced mode in a polyphase model and a polyphase
system. In the balanced mode, the phase voltage and the line voltage are set for all phases at once.
To enter the balanced mode, select the [Osc] soft-key → [6: Phase Mode] to open the phase mode set
window, and select [1:Balance] in the Mode item. For details on the unbalanced mode, see 4.15.
Operation procedures for setting the phase voltage
1. Check the icon in the output display area (see 5.1) is
or single-phase three-wire system)/
different icon is shown, press the [Osc] soft-key and select [5:Target Phs] → [4:All Phs]. Or
perform the Shortcut operation
54
(three-phase model or three-phase system). If the
+
to switch to [All Phs].
PROGRAMMABLE AC POWER SOURCE
(single-phase three-wire model