Using Usb Memory Function; Figure 4-23 Usb Memory Folder Structure - NF DP015S Instruction Manual

 SIM Recall
In the Memory View, select [SIM Recall] to change to the Simulation Recall View as below,
allowing you to load the simulation. For the operation method, see 4.3.6.
4.9

Using USB Memory Function

This product supports the mass storage class USB memory. The arbitrary waveform data, sequence
data, simulation data, and Basic Setting Memory can be saved into and loaded from the USB
memory.
When you connect a USB memory to this product, a window opens with the confirmation message
"USB Memory Connected," then closes after a while.
The root folder of the USB memory should have folders as shown in Figure 4–23. Otherwise, these
folders are created automatically when the USB memory is connected to this product.
To remove the USB memory connected to this product, the eject operation is necessary as explained
in this section.
CAUTION
 Do not connect anything other than a USB memory to the front USB memory connector.
 Before removing the USB memory from this product, always perform the eject operation (see the
next section). Removing the USB memory while it is being accessed may damage the data.
 Do not turn off this product while it is accessing the data in the USB memory.
DP Series

Figure 4-23 USB Memory Folder Structure

4.9 Using USB Memory Function

Arbitrary waveform data
任意波形データ
Basic Setting Memory data
基本設定メモリデータ
Sequence data
シーケンスデータ
Simulation data
シミュレーションデータ
System file
システムファイル
153