Simple Operation Check - NF DP015S Instruction Manual

2.7

Simple Operation Check

This section describes how to perform a simple operation check when you purchased a new product,
or after storing the product for a long period. This check should be performed without load. For a
polyphase system, remove the System Cable, and check the single-phase output for each cabinet. If
you are not satisfied with the results verified at the operation check, please request the repair to us or
our agent.
 Operation procedure
1. Connect the power supply referring to "2.4 Grounding and Power Connections."
2. Attach the resin-molded output terminal cover and the output cable holder without connecting
anything to the output terminals or any other terminal/connector.
3. «Only for Multi-phase model» For the Multi-phase model, set the phase mode setting switch
according to the output phase mode to be checked.
DP Series
1φ2W
1φ3W

2.7 Simple Operation Check

OUTPUT
Hi
Lo
Nothing is connected to
the output terminal.
スイッチをスライドさせて設定す
Set the switch by sliding it.
3φ4W
27