4. Advanced Operation
Table 4-8 Different Output Voltage Settings Depending on Clip Depth Setting Method
Clip Depth Setting Method
Crest factor
Clip ratio
-------- Notes----------------------------------------------------------------------------------------------------------------
When the clipped sine wave is output in the AC mode, the clip of the output waveform may be
tilted by the DC component remove function in the AC mode. To avoid this, switch to the
ACDC mode.
---------------------------------------------------------------------------------------------------------------------------------
Operation procedure
1. In the [Wave] item, select [CLP].
2. Move the cursor to [Select], then select it. The clipped sine wave setting window opens.
132
Output Voltage Setting Method
Sets the RMS of the clipped waveform
Sets the RMS of the sine wave before clipping
PROGRAMMABLE AC POWER SOURCE